Products

Simplex sprocket, suits 08B chain with 21 teeth. Sprocket secures with grub screws to a 20mm shaft. Old Part No. 115-420 Model SKU: 115-4020; Cha...

Simplex sprocket, suits 08B chain with 21 teeth. Sprocket secures with grub screws to a 25.4mm shaft. Old Part No. 113-451 Model SKU: 113-4051; C...

Simplex sprocket, suits 08B chain with 24 teeth. Sprocket secures on a 20mm shaft with grub screws. Model SKU: 630-4110; Chain: 08B; Teeth: 24; Sh...

Simplex sprocket, suits 08B chain with 27 teeth. Sprocket fits to a 20mm shaft and secures with grub screws. Identical to part 630-4119

Simplex sprocket, suits 08B chain with 60 teeth. Sprocket fits to a 20mm shaft and secures with grub screws.

24 Tooth Simplex sprocket to suit a 10B Chain. It has been machined out to suit a 60mm shaft. Predominately used on the AD95. Requires 2x #115-7013...

24 TOOTH SIMPLEX SPROCKET, 5/8" PITCH, 25.4 (1") ID BORE

36T PRIMARY DRIVE SPROCKET primarily used on the JPC2000. This sprocket is driven by a 10B chain.

Fabricated fixed idler sprocket. Suits 08B chain with two 21 tooth sprockets. Sprockets secure with grub screws to a 25.4mm shaft.

These Agrowplow stroke controllers are spring-loaded for easy installation and have nylon rods inserted, designed to protect the cylinder rods from...

These Agrowplow stroke controllers are spring-loaded for easy installation and have nylon rods inserted, designed to protect the cylinder rods from...

Tapered Roller Bearing suits AP81 and AP91 wheel assemblies. Used on the 10-stud KHitch hub assembly. There are two bearings utilized per hub.

10STUD HUB CAP, suits AP81 and AP91 machines. HUB CAP ONLY. This is used in tandem with an O-ring to seal the 10 Stud K-Hitch hub.

CROWN NUT, suits AP81 and AP91 machines. CROWN NUT ONLY

Machined hub part to suit 10 stud axle assembly on AP81, AP91 and AP92 machines. This hub is used in conjunction with these parts:  1 x HUB CAP    ...

Dust cap or Hub cap to suit the 50 series hub used on the AD130.

6 x 205 PCD HUB and STUB assembly. Suits the AD230 and AP51 Parts supplied unassembled. Please factor this into setup estimates. Alt Part Number...

This dust cap suits the AD230 and AD240 stub axles. It has three mounting holes with a grease nipple in the centre. Also known as a dust cover or a...

6 x 205 PCD HUB and STUB assembly. SUITS THE AD240 Parts are supplied unassembled. Please factor this into setup estimates.

Sweeps are designed for the #9 and #8 shank assemblies and can fit to any shank with 22mm 1/2" holes. Sweeps increase the shanks effect on the grou...

This bearing spacer is utilised on the #9 Hydraulic Swing arm and has been designed to fit through a 40mm bearing. There are 2 spacers utilised per...