Skip to content
LIMITED AD640 LAUNCH SPECIAL: First 5 units only! CHOOSE YOUR DEAL →
LIMITED AD640 LAUNCH SPECIAL: First 5 units only! CHOOSE YOUR DEAL →
ABOUT AGROWPLOW CONTACT US SEED DRILL CALIBRATION
← Agrowdrill Knowledgebase

Agrowdrill Calibration Calculator

Step through this guide to set up your machine and verify your sowing rate before heading to the paddock.

1 Machine & Row Configuration
Set gate, restrictors and rate adjustment levers, then insert calibration tray and seed
Turn the calibration handle anticlockwise
—
Collect the seed from the 5 hoses/outlets and weigh
2 Seed Type & Target Rate optional
⚠ Seed rate data not available for this model. Please refer to your operator's manual or contact Agrowplow on 1300 722 491.
3 Weigh & Calculate Actual Rate

After turning the handle the required number of times, weigh the total seed collected from 5 hoses and enter it below.

Loading calibration data…
The Small Seeds Box (SSB) is calibrated separately from the main drill using the same calibration factor and handle turns. Complete Step 1 on the Main Drill tab first, or enter values manually from your machine plate.

🔔 Low Gear is the factory default. Set gear by placing the chain on the appropriate sprockets before calibrating.
1 Gear & Machine Settings
✓ Pre-filled from your main drill configuration
2 Seed Type & Target Rate
3 Weigh & Calculate

Prime the seed rollers first, then collect from the 5 SSB hoses after the required handle turns and weigh.

ⓘ Adjusting sowing rate: Use the drive bar to make minor adjustments. If you cannot get the seeding rate high or low enough, move the chain between High and Low gear sprockets.
Full SSB instructions: Agrowplow calibration guide

Agrowdrill Calibration

NEED MORE SUPPORT?

Speak to Someone

1300 722 491

Agrowdrill Parts

Shop Now

Agrowdrill Manuals

Operator and parts manuals

Find a Dealer

Locate your local supplier