Products

This bearing spacer is utilised on the #9 Hydraulic Swing arm and has been designed to fit through a 40mm bearing. There are 2 spacers utilised per...

Tee-bolt used on the #7, #8 spring jump, and #Econo Shank Assemblies. The tee-bolt runs through the centre of the spring to secure it to the assemb...

Tension spring used in the current AD140 drive assembly. It is made out of 6.3mm Wire Gal, has an OD of 59mm and has around 28 total coils. This sp...

Chain tensioner made in engineering plastic, outer diameter 30mm, 50mm long. Supplied with nut to secure in drive assembly. *Old Part No. 124-485

Chain tensioner made in engineering plastic, outer diameter 30mm, 55mm long. Supplied with nut to secure in drive assembly.

Chain tensioner made in engineering plastic, outer diameter 30mm, 75mm long. Supplied with nut to secure in drive assembly.

Chain tensioner made in engineering plastic, outer diameter 40mm, 105mm long.

Chain tensioner made in engineering plastic, outer diameter 40mm, 135mm long.

Chain tensioner made in engineering plastic, outer diameter 30mm, 50mm long. Equivalent Part No. 124-4085

Chain tensioner made in engineering plastic, outer diameter 50mm, 40mm long. Supplied with nut to secure in drive assembly. *Old Part No. 124-484

Chain tensioner made in engineering plastic, outer diameter 50mm, 80mm long.

Nylon chain tensioner cut from 70mm rod. Used on seed drill assemblies including the 13 and 18 run Agrowpdrills and the 3000 and 3400 seed drill mo...

(x2) offsets are required to update an AD230. This is intended to shift the front tynes forward by 150mm in the case that the tyne is fitted with d...

Top cylinder pin commonly used on the 3000 series Agrowdrill. It is made out of a 25.4mm bright shaft, is 250mm long and comes with two holes drill...

Jumbo Top Link, 1 3/8" UNC THREAD Dia. CAT2 Eyelets 1" BallEnd Adjustment range 63cm to 91cm (24.75" to 35.75")

The 251 Spring Tyne Assembly suits the Agrowdrill AD730 and is a dependable and cost-effective undercarriage for a range of sowing applications. Th...

 Complete parts set for the 325 Tyne Assembly. The assembly includes coil tyne, a clamp to suit 100x100mm RHS, seed boot, and baker boot point.  S...

Complete parts set for the 425 Tyne Assembly. Includes tyne, tyne clamp, seed boot, and baker boot point with tungsten tile.  Fits the Agrowdrill...

This heavy-duty spring tyne assembly has 720mm of frame clearance and 550 pounds break out. Assembly comes with mounting and point. Seed tube, seed...

The 552 Heavy Duty Spring Tyne Undercarriage is the most versatile and hard-wearing undercarriage for Agrowdrill direct drills. A range of point op...

The 700 Coil Tyne was a tyne assembly used on earlier model Agrowdrills, including the AD3000, ADx00 series drills, and JPC 2000. It used a 25mm co...