Products

Spring jump pivot clamp to suit 100mm or 4" RHS. Suits the #7 spring jump shank assembly. Also known as a carrier plate. Old Part No. 001-102

Coulter assembly kit to suit ploughs with #9 Shank Assemblies with hydraulic breakout.  Coulters mount to the shank assembly ahead of the shanks, b...

Attach coulters to your plough to help break through the trash. Suits the hydraulic recoil assemblies for the #8 and #8-9 hybrid shank. For rigid s...

Attach coulters to your plough to help break through the trash. Suits the rigid shearpin breakout assemblies for the #8 and #8-9 hybrid shank. For ...

Coulter assembly to suit ploughs with #9 Shank Assemblies with rigid and hydraulic breakout. Coulters are available with either 12" or 14" plain di...

PRESSURE GAUGE FOR ACCUMULATOR

Presswheel plate to suit 15" presswheels, 5x108PCD. (x2) plates required to for a wheel rim, see 427-2001 for a full assembly with wedge profile ty...

This is a full parts kit for our 125mm dual-wheel presswheel assembly for mounting to 65x65mm RHS.  Bulk discounts are available for multiple sets...

This is a full parts kit for our 150mm dual-wheel presswheel assembly for mounting to 65x65mm RHS.  Bulk discounts are available for multiple sets...

This is a full parts kit for our single-wheel press wheel assembly for mounting to 65x65mm RHS.  Bulk discounts are available for multiple sets. C...

Presswheel down tubes to suit dual 125mm rows, 427-1002.

Presswheel down tubes to suit dual 150mm rows, 427-1003.

Fabricated knuckle component. Suits Presswheel assembly 427-100#. Secures the spring, arm assembly and pivots.

Pivot bush, suits presswheel assemblies 427-100#. Required in both the horizontal and vertical pivots inside the knuckle.

Presswheel down tubes to suit 175mm rows and over, 427-1001.

Torsion spring suits presswheel assemblies 427-100#.

Presswheel tyre 15", wedge profile, suits 11" rim. See 427-2001 for a full assembly including rims and hardware.

Presswheel tyre and rim assembly to suit the 427-100# Presswheel series. The assembly includes an 82mm diameter wedge-profile tyre and 280mm rim pl...

Punch specifically designed to remove worn bushes and insert the steel-backed teflon bushes into the #9 Shank.

Punch specifically designed to secure the 12mm roll pin 140-4087 and 4077 into the #9 Blade. This punch is made out of 4140 steel and has been hard...

Punch specifically designed to secure the 7/16" roll pins into the #9 Hydraulic Shank Assembly. This punch is made out of 4140 steel and has been h...