Baker Boot Point 325 - Fabricated Hardfaced (with Imperial Hardware)
Baker Boot Point 325 - Fabricated Hardfaced (with Imperial Hardware) Description:
Premium fabricated hardfaced baker boot point to suit the 325 Coil Tyne assembly. Also fits various third-party seed drills and coil tynes.
An extended variant (115-3032) with tile and hardfacing is also available for deeper sowing depths.
Manufactured in Australia from 6mm Bisalloy plate, this point is fully fabricated rather than cast. Fabricated construction provides greater structural integrity and resistance to cracking under load compared to cast alternatives. It is built to withstand extreme wear while maintaining cutting efficiency and consistent slot formation. Many operators report multiple seasons of service, reduced changeovers, and lower wear-part cost per hectare.
All leading edges are reinforced with tungsten carbide chip and hardfaced welding for extended wear life. Compared to non-hardfaced points, this design delivers significantly improved resistance to abrasion and impact in harsh soils.
Produces a clean inverted “T” groove for accurate seed placement, strong seed-to-soil contact and minimal soil disturbance, supporting reliable germination and establishment.
This is the same fabricated point used on the 425 assembly. The 325 baker boot is supplied with the following imperial hardware to attach to your 325 tyne (60mm hole centres):
- 2 x BOLT 3/8" x 1" UNC G8 Zinc (133-0070)
- 2 x WASHER SPRING 3/8" ZINC (135-0030)
- 2 x NUT HEX 3/8" UNC ZINC (134-0030)
Also available:
- Baker Boot Point - Cast Hardfaced (no hardware) (114-4250)
- Baker Boot Point 325 (Extended) - Fabricated Hardfaced (with Imperial Hardware) (115-3032)
- Baker Boot Point 425 - Fabricated Hardfaced (with Metric Hardware) (115-4032)
Alternate Part No: 115-3027