Baker Boot Point 325 (Extended) - Fabricated Hardfaced (with Imperial Hardware)
Baker Boot Point 325 (Extended) - Fabricated Hardfaced (with Imperial Hardware) Description:
Extended fabricated hardfaced baker boot point to suit the 325 Coil Tyne assembly. Designed for deeper sowing depths on older Agrowdrills and compatible with various third-party seed drills and coil tyne assemblies.
A standard-sized point (115-4011) with tile and hardfacing is also available.
Manufactured in Australia from 6mm Bisalloy plate, this point is fully fabricated rather than cast, providing greater structural integrity and improved resistance to cracking under load. It is built to handle extreme wear while maintaining cutting efficiency and consistent slot formation. Many operators report multiple seasons of service in abrasive conditions, reducing changeovers and lowering cost per hectare.
All leading edges are reinforced with heavy-duty tungsten carbide chip and hardfaced welding for extended wear life. Compared to non-hardfaced points, this design delivers significantly improved resistance to abrasion and impact in harsh soils.
Supplied with the following imperial hardware:
- 2 x BOLT 3/8" x 1" UNC G8 Zinc (133-0070)
- 2 x WASHER SPRING 3/8" ZINC (135-0030)
- 2 x NUT HEX 3/8" UNC ZINC (134-0030)
Also available: