Products

Built exclusively for the AP102 deep ripper, this heavy-duty hardfaced point is built tough and ready for the rigours of ripping down to 750 mm.

Hex shaft used in Agrowdrill seed box roller assemblies. Hex shafts are available in either 3.6 or 4.8m lengths and can be cut to size to suit the ...

Swivel hitch tow eye for Agrowdrill AD230 and FLexiroller MK2 HD A-frame trailing hitch assemblies. Has an eye internal diameter of 52mm.

Gate lever arm to suit the AD130 and AD230 machines. Fits to the gate bar. Includes handle.

19mm seed tube hose. Supplied in 1m lengths per unit ordered. Maximum available coil length is 20m. Other sizes available:  25.4mm diameter [25.4...

25.4mm seed tube hose. Supplied in 1m lengths per unit ordered. Maximum available coil length is 20m. Other sizes available:  19mm diameter [19/2...

31.75mm (1¼") seed tube hose. Supplied in 1m lengths per unit ordered. Maximum available coil length is 20m.This Barflo hose suits single-gate hous...

38mm (1½") seed tube hose. Supplied in 1m lengths per unit ordered. Maximum available coil length is 20m.This Barflo hose suits double-gate housing...

Hose clamp is utilised on the 425 Tyne Assembly to hold the 38mm Barflo hose onto the Seed tube.

Holds 43mm OD hose on FLEXI CHUTES

Clear vinyl tube used on small seed boxes and pasture seeders. 19.5mm ID / 25mm OD. When ordering 1 Unit = 1 Metre *Old Part No. 219-412

Used on hydraulic cylinder 153-4208 Alternate part no. 153-4304

3/4" JIC MALE, 3/4" UN O RING MALE

HYDRAULIC FLUID PORT REDUCING BUSHES 2" TO 3/4" BSPPF

Used in the #8 and #1 Hydraulic Assemblies. Fits in the port of cylinder 153-4200.

Used in the #9 Assemblies.

1.1/4" diameter pin, 5" working width. Pin suits the #8 shank and #1 shank hydraulic recoil assemblies. See 120-0001, 120-0003, 120-0007, 005-10...

Current hydraulic cylinder for the #9 Hydraulic Shank Assembly. Has a 3" bore and 9" cylinder rod displacement. Pin-eye cylinder bush is 30.2mm str...

Hydraulic jump cylinder for the Agrowplow #1 and 8 hydraulic shank assemblies. Has a 2.1/2" bore and a 9" rod displacement. 

Suits #9 hyd shank

Hydraulic stroke control segments stop the hydraulic cylinder from closing by increments. On a phasing set, only the drive cylinder needs to be con...

This idle shaft is made out of 25.4mm (1") Stainless steel and is 315mm long. It has a key-way machined in the entire length of the shaft for secur...

Wear plates protect inclusion plates from damage through repeated use, increasing their lifespan. Wear plates are sold individually; two plates ar...

Inclusion plate with wear plates. Wear plates can be easily replaced saving huge cost in material and time. Designed for the #9 shank and may suit ...

Splitter plates for the #9 Inversion Shank Assembly. The inversion shank is designed to lift soil from the bottom of the working depth up toward th...