Agrowdrill

Fabricated fixed idler sprocket. Suits 08B chain with two 21 tooth sprockets. Sprockets secure with grub screws to a 25.4mm shaft.

Dust cap or Hub cap to suit the 50 series hub used on the AD130.

Tension spring used in the current AD140 drive assembly. It is made out of 6.3mm Wire Gal, has an OD of 59mm and has around 28 total coils. This sp...

Chain tensioner made in engineering plastic, outer diameter 30mm, 50mm long. Supplied with nut to secure in drive assembly. *Old Part No. 124-485

Chain tensioner made in engineering plastic, outer diameter 30mm, 55mm long. Supplied with nut to secure in drive assembly.

Chain tensioner made in engineering plastic, outer diameter 30mm, 75mm long. Supplied with nut to secure in drive assembly.

Chain tensioner made in engineering plastic, outer diameter 40mm, 105mm long.

Chain tensioner made in engineering plastic, outer diameter 40mm, 135mm long.

Chain tensioner made in engineering plastic, outer diameter 30mm, 50mm long. Equivalent Part No. 124-4085

Chain tensioner made in engineering plastic, outer diameter 50mm, 40mm long. Supplied with nut to secure in drive assembly. *Old Part No. 124-484

Nylon chain tensioner cut from 70mm rod. Used on seed drill assemblies including the 13 and 18 run Agrowpdrills and the 3000 and 3400 seed drill mo...

(x2) offsets are required to update an AD230. This is intended to shift the front tynes forward by 150mm in the case that the tyne is fitted with d...

Top cylinder pin commonly used on the 3000 series Agrowdrill. It is made out of a 25.4mm bright shaft, is 250mm long and comes with two holes drill...

Jumbo Top Link, 1 3/8" UNC THREAD Dia. CAT2 Eyelets 1" BallEnd Adjustment range 63cm to 91cm (24.75" to 35.75")

25mm coil tyne assembly used on ADx20 series Agrowdrill direct drills. The assembly includes a clamp to suit 100x100mm RHS, seed boot, and baker bo...

Complete parts set for the 425 Tyne Assembly. Includes tyne, tyne clamp, seed boot, and baker boot point with tungsten tile.  Fits the Agrowdrill ...

The 700 Coil Tyne was a tyne assembly used on earlier model Agrowdrills, including the AD3000, ADx00 series drills, and JPC 2000. It used a 25mm co...

The 732 Coil Tyne Assembly is a heavy-duty tyne assembly used on some older model Agrowdrill direct drills, including the AD3000, ADx00 series mach...

Fastener kit for the 732, 700, 425, and 325 tyne assemblies. Used to secure the tyne bolt clamp (115-3009). Includes an M16x200 bolt, plus a nut an...

Tyne clamp used as part of a tyne clamp assembly to secure Agrowdrill tynes to the machine toolbar. Suits 100mm x100mm RHS, for all 25mm coil sprin...

Suits 732 tyne